Methods

Sites are designated according to the NTL numbering scheme established for the shoreline of the south basin of Trout Lake and its islands. The four sites (Trout-07, 46.01809769, -89.65571661; Trout-31, 46.0430698, -89.67157974; Trout-50, 46.01729465, -89.69461296; Trout-56, 46.01921135, -89.6813004) used by the macrophyte component are also used in the NTL fish and crayfish sampling. The site descriptions specify a transect line along which presence or absence data is recorded for all macrophyte species. A 0.25 M2 ring placed at 1 meter intervals (except site 7 - 0.5 to 1 M depth where the ring is placed at 2 meter intervals) along the transect designates the sampling quadrat. Using SCUBA, species data are recorded along with the total number of quadrats encountered between the following depth intervals: 0.5-1 M, 1-2 M, 2-3 M and 3-5 M. These depth intervals have been permanently established with markers consisting of a commercial Earth Anchor set in the lake bottom with 2 floats secured to it near the bottom. Large boat bumpers are used on the anchors at 3 and 5 meters. Between 28 and 52 quadrats are examined within each depth interval at each site.
Pre-1987 Data. In 1987, permanent line transects were established at each of the sites. Biomass samples and line transects observed before 1987 were set by more general descriptions at the site and were not identical year to year.

Methods

Sites are designated according to the NTL numbering scheme established for the shoreline of the south basin of Trout Lake and its islands. The four sites (Trout-07, 46.01809769, -89.65571661; Trout-31, 46.0430698, -89.67157974; Trout-50, 46.01729465, -89.69461296; Trout-56, 46.01921135, -89.6813004) used by the macrophyte component are also used in the NTL fish and crayfish sampling. The site descriptions specify a transect line along which presence or absence data is recorded for all macrophyte species. A 0.25 M2 ring placed at 1 meter intervals (except site 7 - 0.5 to 1 M depth where the ring is placed at 2 meter intervals) along the transect designates the sampling quadrat. Using SCUBA, species data are recorded along with the total number of quadrats encountered between the following depth intervals: 0.5-1 M, 1-2 M, 2-3 M and 3-5 M. These depth intervals have been permanently established with markers consisting of a commercial Earth Anchor set in the lake bottom with 2 floats secured to it near the bottom. Large boat bumpers are used on the anchors at 3 and 5 meters. Between 28 and 52 quadrats are examined within each depth interval at each site.
Pre-1987 Data. In 1987, permanent line transects were established at each of the sites. Biomass samples and line transects observed before 1987 were set by more general descriptions at the site and were not identical year to year.

Methods

Sites are designated according to the NTL numbering scheme established for the shoreline of the south basin of Trout Lake and its islands. The four sites (Trout-07, 46.01809769, -89.65571661; Trout-31, 46.0430698, -89.67157974; Trout-50, 46.01729465, -89.69461296; Trout-56, 46.01921135, -89.6813004) used by the macrophyte component are also used in the NTL fish and crayfish sampling. The site descriptions specify a transect line along which presence or absence data is recorded for all macrophyte species. A 0.25 M2 ring placed at 1 meter intervals (except site 7 - 0.5 to 1 M depth where the ring is placed at 2 meter intervals) along the transect designates the sampling quadrat. Using SCUBA, species data are recorded along with the total number of quadrats encountered between the following depth intervals: 0.5-1 M, 1-2 M, 2-3 M and 3-5 M. These depth intervals have been permanently established with markers consisting of a commercial Earth Anchor set in the lake bottom with 2 floats secured to it near the bottom. Large boat bumpers are used on the anchors at 3 and 5 meters. Between 28 and 52 quadrats are examined within each depth interval at each site.
Pre-1987 Data. In 1987, permanent line transects were established at each of the sites. Biomass samples and line transects observed before 1987 were set by more general descriptions at the site and were not identical year to year.

Methods

Sites are designated according to the NTL numbering scheme established for the shoreline of the south basin of Trout Lake and its islands. The four sites (Trout-07, 46.01809769, -89.65571661; Trout-31, 46.0430698, -89.67157974; Trout-50, 46.01729465, -89.69461296; Trout-56, 46.01921135, -89.6813004) used by the macrophyte component are also used in the NTL fish and crayfish sampling. Five replicate quadrats (0.25 M2) are harvested for all above ground biomass at each site at each of three nominal depths: 1.5 M, 2.5 M and 4 M. Samples are removed along a line parallel to shore - located midway between sites for cover estimates. Four sites with 3 depths and 5 replicates yields 60 samples. In the lab, samples are separated by species and are dried and weighed. From 1989 to 2008 plants were placed in labeled paper bags oven dried, and weights recorded. Biomass weights were determined by weighing dried plants in paper bags and using an average tare for the bags. Consequently, values in the data base can be negative and should be considered as present in very small amounts.
Pre-1987 Data. In 1987, permanent line transects were established at each of the sites. Biomass samples and line transects observed before 1987 were set by more general descriptions at the site and were not identical year to year.

Methods

Aquatic macrophytes are sampled from a boat at stations located at depths from 1 to 4 meters at 0.5-m intervals along transects perpendicular to the lake shoreline of the four primary study lakes in the Madison area (Lakes Mendota, Monona, and Wingra, and Fish Lake) from June to August. A weighted, double-headed garden rake is cast off the front left, front right, rear left, and rear right of the boat and then dragged approximately 2 meters across the bottom by means of an attached line. The total plant mass and the total filamentous algae mass in each tow is measured. To the maximum extent possible, water is squeezed from the plants to minimize the amount of water present in the final weight. Weights are recorded in the boat using field scales. Weights from the 4 rake casts at each station can be averaged to compute overall average weights for plant mass and for filamentous algae mass at the station.
Detailed Macrophyte Sampling description.
Using the site book and the depth measuring pole, move to the 1 meter depth mark and throw both anchors. From the Macrophyte Depth Table, find the distance to throw out the rake and the meter mark that the line should be drawn to. The table is calculated to determine the starting and ending meter marks to draw in the line to allow the rake to drag 2 meters on the lake bottom. Pull the rake quickly out of the water. If a significant amount of dirt has been brought up with the plants (i.e. the weight of the dirt will add significantly to the total weight), wash the plants. Depending on the volume of the plants, wash them either by keeping them in your hands and dunking them in the lake or by putting them in a bucket with drain holes. Separate the filamentous algae from the rest of the plant material. Squeeze out as much water as possible (it may be necessary to divide up the plant material into portions to effectively squeeze out the water). Weigh the plant material (minus the filamentous algae) and record the total weight. Weigh the filamentous algae and record the weight. Repeat the above steps until 4 rake tosses have been thrown. Move to the next half-meter depth. Macrophytes are collected at each half-meter water depth from 1 meter to 4 meters.

Methods

Aquatic macrophytes are sampled from a boat at stations located at depths from 1 to 4 meters at 0.5-m intervals along transects perpendicular to the lake shoreline of the four primary study lakes in the Madison area (Lakes Mendota, Monona, and Wingra, and Fish Lake) from June to August. A weighted, double-headed garden rake is cast off the front left, front right, rear left, and rear right of the boat and then dragged approximately 2 meters across the bottom by means of an attached line. For each rake cast, filamentous algae and any aquatic macrophyte species present are assigned a density rating from 0-5 based on the extent of coverage of the upper rake head. Determination of extent of coverage involves judgment of the surveyor as to the number of rake teeth and area of teeth covered by each species. It is necessary to separate plants to assess individual species coverage. Ratings from the 4 rake casts at each station can be averaged to compute an overall density rating for each species found at the station.
Detailed Macrophyte Sampling description.
Using the site book and the depth measuring pole, move to the 1 meter depth mark and throw both anchors. From the Macrophyte Depth Table, find the distance to throw out the rake and the meter mark that the line should be drawn to. The table is calculated to determine the starting and ending meter marks to draw in the line to allow the rake to drag 2 meters on the lake bottom. Pull the rake quickly out of the water. Before removing the plant material from the rake, drape the long strands over the rake and gently push the plant material down on the rake. Assign a rake rating (from 1 to 5) depending on how much the plant material covers the rake prongs. The rake prongs are painted in 20 percent increments. If the plant material only covers the lowest 20 percent of the rake prongs, assign the rake rating a 1. If the plant material covers between 20 percent and 40 percent of the rake prongs, the rake rating is a 2, and so on. If a significant amount of dirt has been brought up with the plants (i.e. the weight of the dirt will add significantly to the total weight), wash the plants. Separate the filamentous algae from the rest of the plant material. Separate and identify the individual plant species, throwing out any dead plant material. Give the filamentous algae and each plant species a rake rating (note that it is often necessary to visualize how much space each species would take up on the rake prongs rather than actually placing each species onto the rake). If a plant species can not be identified, take a sample back to the lab by putting it in a ziplock bag with a small amount of water and temporarily storing it in a cooler. Repeat the above steps until 4 rake tosses have been thrown. Normally 2 rake tosses are thrown out each side of the boat to an area where the water depth is known to be at the desired depth. Move to the next half-meter depth. Macrophytes are collected at each half-meter water depth from 1 meter to 4 meters.

Methods

Sites are designated according to the NTL numbering scheme established for the shoreline of the south basin of Trout Lake and its islands. The four sites (Trout-07, 46.01809769, -89.65571661; Trout-31, 46.0430698, -89.67157974; Trout-50, 46.01729465, -89.69461296; Trout-56, 46.01921135, -89.6813004) used by the macrophyte component are also used in the NTL fish and crayfish sampling. Five replicate quadrats (0.25 M2) are harvested for all above ground biomass at each site at each of three nominal depths: 1.5 M, 2.5 M and 4 M. Samples are removed along a line parallel to shore - located midway between sites for cover estimates. Four sites with 3 depths and 5 replicates yields 60 samples. In the lab, samples are separated by species and are dried and weighed. From 1989 to 2008 plants were placed in labeled paper bags oven dried, and weights recorded. Biomass weights were determined by weighing dried plants in paper bags and using an average tare for the bags. Consequently, values in the data base can be negative and should be considered as present in very small amounts.
Pre-1987 Data. In 1987, permanent line transects were established at each of the sites. Biomass samples and line transects observed before 1987 were set by more general descriptions at the site and were not identical year to year.

Methods

CRAYFISH AND MINNOW TRAPS There have been introductions of exotic crayfish species in recent years into many north temperate lakes. Monitoring yearly abundances of crayfish species is important in determining the status and extent of the invasions.Crayfish traps are set on all lakes except the bog lakes (Crystal Bog and Trout Bog). Minnow traps are set only on the bog lakes. Prior to 1998, five traps were set at each fyke net site. Starting in 1998, three traps are set per site. Thus, prior to 1998, thirty traps were set on each lake (covering 6 sites.) As of 1998, 18 traps are set on each lake.Minnow traps and crayfish traps are set in shallow water (approx 1 m), 2 traps on one side, and 1 trap on the other side of the fyke net lead. Minnow traps are baited with 1 slice of bread per trap to attract minnows inhabiting the bogs. Crayfish traps are baited with 120 g of liver. Traps are fished for approximately 24 hours . Crayfish are identified to species and returned to the lake, except 2001 - 2008 when in Sparkling Lake Rusty Crayfish (Orconectes rusticus) was removed. Minnows caught in either the crayfish or minnow traps are identified to species, measured for total length.Minnow traps used are galvanized steel two piece traps, 44.5 cm long by 30.5 cm maximum diameter with 2.5 cm diameter openings at the ends. The mesh size is 6.4 mm on a side. Crayfish traps are identical, but the opening hole of both sides of the trap has been forced to 5 to 7 cm.

Methods

Details of field collections can be found in Wilson, K.A. 2002. Impacts of the invasive rusty crayfish (Orconectes rusticus) in northern Wisconsin lakes. Ph.D. Dissertation. University of Wisconsin, Madison.